Gen II User Manual
4-7 – Propeller Balance Chapter 4 Revision 2.2, Apr 2020
4.1. – Start Job
Selecting “Start Job” from the “Propeller Balance” banner screen allows you to begin a new
propeller balance job. When you select this option, one of three screens will appear depending on
whether you are: 1) Starting a new job with no setups previously defined in the analyzer’s
memory; 2) starting a new job with previously-defined setups available in the analyzer’s
memory; or 3) resuming an incomplete job being held in the analyzer’s memory.
If you are starting a new job with no setups previously defined in the analyzer’s memory, the
screen will automatically display the Prop Balance Setup banner screen shown below. See
paragraph 4.1.1. for step-by-step instructions on completing the Prop Balance Setup.
To Next Page
Loading...
