Gen II User Manual
8-29 – Tail Rotor Balance Chapter 8 Revision 3.00, April 2020
pressing the [] key to exit the field, the value entered in this field will
change the remainder of the screen to allow input of each weight
position’s ICF.
Wt/Pos, Grams, IPS, Add @:
Starting with any of the correction points on the chart. Enter the weight position name
in the first field up to six characters. “TARGET” is the first weight position name in
our example.
Press the [] key and move to the next field. Enter the amount of adjustment portion
of the ICF under “Grams”. This example uses “10.00” grams.
Press the [] key and enter the amplitude reference for the amount of adjustment just
entered. For this example, enter “1.0” IPS
Press the [] key to move to the “Add @” field. Enter the clock angle move line for
this point. For the “TARGET” weight position the move line is “6:00”.
Perform this for each adjustment point shown on the chart to complete the setup.
Note:
Weight position names must be entered sequentially in either clockwise or counterclockwise
order. It does not matter what direction is chosen.
Revision History:
3/12/2015 1.01: Moved Analyzer Chart Forms section from 8.1 to 8.8 and added Revision history table. Berlin
11/9/2015 1.02: Added text about the Polar Chart view. Main Polar view explanation in Chapter 24. Lucas
2/12/2016 2.00: Major rewrite generalizing the manual to cover both the Viper II and Cobra II. This chapter was
updated with screenshots and corrections to minor typographical errors.
East
1 April 2020 3.00: Major rewrite to the manual. This chapter was updated with screenshots, corrections and updates. Underwood
To Next Page
Loading...
Need help?
General
