Gen II User Manual
9-20 – Transient Balance Chapter 9 Revision 2.10, Apr 2020
9.2.2. – Engine Information Screen
9.2.2.1. The Engine Information screen will be displayed where you may enter the optional
information of Position, Engine S/N, Type, TSO, TSN, and Cyc. Complete each field
as necessary using the analyzer keypad. If Engine Serial Numbers have previously
been entered in this analyzer, you may optionally press the [F3] “Eng S/N” key and
select a serial number from the stored list of serial numbers. If Engine Types have
previously been entered in this analyzer, you may optionally press the [F4] “Eng
Type” key and select a type from the stored list of types. When all fields are complete
per your requirements, press [OK] to accept and continue.
To Next Page
Loading...
