Gen II User Manual
10-27 – Fan/Turbine Balance Chapter 10 Revision 2.10, Apr 2020
[F4] “Sel Pla/Wt” – Appears if optional balance planes or multiple class weight sets are
configured in the setup. The “Select Plane / Class Wt Set” screen and allows you to select
an optional balance plane and/or weight set.
[F5] “Quit Job” – Allows you to terminate this job without the option to resume at a later
time.
[F6] “Graph” – Displays a graph of the balance plane as viewed from the perspective
chosen in paragraph 10.1.4.11 above. The graph will display position location(s)
identified in the solution (1 in the example above). The line represents the effective angle
of the calculated solution.
To Next Page
Loading...
