Gen II User Manual
11-2 – Fan Blade Mapper Chapter 11 Revision 3.00, Apr 2020
11.1.2. – Select Setup List
11.1.2.1. If no setups were previously entered, the analyzer will open a new setup screen as
shown in paragraph 11.1.2.2 below. If a setup has previously been entered for the
engine model you are currently working, you may select it from the “Select, Setup
List” as illustrated in the screen sample below and proceed to paragraph 11.1.3. If
your engine model is not listed, press the [F1] “New” key and proceed to
paragraph 11.1.2.2.
11.1.2.2. In the Fan Blade Mapper Setup screen, shown below, use the [] key to move
from field to field and complete the screen as follows:
To Next Page
Loading...
