Gen II User Manual
13-3 – Transient Vibration Survey Chapter 13 Revision 4.10, Apr 20
“Select Setup List”. If you are starting a new job with previously defined setups available in the
analyzer’s memory, the screen will automatically display the “Select Setup List” banner screen
similar to the one shown below. The actual setup names will be those which you have entered
into your analyzer.
“Transient Survey Setup” Screen. If you are starting a new job with no setups previously defined
in the analyzer’s memory, the screen will automatically display the “Transient Survey Setup”
banner screen shown below.
13.1.1. – Transient Survey Setup
The “Transient Survey Setup” banner screen allows you to define and store a transient vibration
survey setup. As shown in the figure below, some fields in this screen have default values that
To Next Page
Loading...
