Gen II User Manual
15-2 – Overall Vibration Survey Chapter 15 Revision 4.10, Apr 20
“Incomplete Job” If another job was in progress but was not completed, the “Incomplete Job”
banner screen will be displayed to inform you of this. The displayed message will give you the
details of the last incomplete job and provide the opportunity to resume it. Pressing the [F1]
“Yes” key will return you to the last logical in-progress step of the job. Pressing the [F5] “No”
key will proceed as described in the two examples below, depending on your circumstances.
“Select Setup List”. If you are starting a new job with previously defined setups available in the
analyzer’s memory, the screen will automatically display the “Select Setup List” banner screen
similar to the one shown below. The actual setup names will be those which you have entered
into your analyzer.
To Next Page
Loading...
Need help?
General
