Gen II User Manual
4-15 – Propeller Balance Chapter 4 Revision 2.2, Apr 2020
4.1.1.3. – Sensor Setup
Pressing the [F5] “Sensor” key from the “Prop Balance Setup” banner screen displays the
“Sensor Setup” banner screen shown below. The information on this screen should correspond to
the sensor you selected for this setup in paragraph 4.1.1.1.199 above.
4.1.1.3.1. This is an information-only screen for use in verifying the parameters of the
vibration sensor you have chosen. You may not edit or otherwise enter
information on this screen. If this sensor does not possess the specifications you
require for this setup, you may enter a new sensor in the “Sensor Setup” screen, or
choose another sensor from the existing list. Press [F0] “Back Up” or [OK] to exit
this screen and return to the “Prop Balance Setup” banner screen.
To Next Page
Loading...
