Index
Index Index-5
WRONG DISK FORMAT,
INITIALIZE DISK
, 10-49
error correction procedure
, 11-4
error messages
, 10-1, 10-44
phase lock
, 7-6
receiver failure
, 8-4
error term inspection
, 9-5
error terms
, 11-1
directivity (EDF and EDR)
, 11-6
isolation (crosstalk EXF and
EXR)
, 11-9
load match (ELF and ELR)
,
11-10
reflection tracking (ERF and
ERR)
, 11-8
source match (ESF and ESR)
,
11-7
transmission tracking (ETF and
ETR)
, 11-11
e-terms
, 11-1
external source
, 1-3
external source mode frequency
range test
, 2-17, 2-98
EXTERNAL TESTS
, 10-5
external tests
, 10-4, 10-10
F
failure
A1/A2 front panel
, 6-12
A11 phase lock and A3 source
check
, 7-8
GPIB
, 6-19
key stuck
, 6-13
phase lock error
, 7-6
receiver
, 8-4
RF power from source
, 7-5
fan
air flow detector
, 12-8
speeds
, 5-19
troubleshooting
, 5-19
variable fan circuit
, 12-8
voltages
, 5-19
faulty analyzer repair
, 4-3
faulty cables
, 9-2
faulty calibration devices or
connectors
, 9-2
faulty data
, 4-18
faulty group isolation
, 4-10
filter, low pass
, 1-3
firmware revision softkey
, 10-41
floppy disk
, 1-3
FM Coil plot with 3 point sweep
,
7-29
FN Count
, 10-10
FN LO at A12 check
, 7-16
FN LO waveform at A12J1
, 7-16
Fr Pan Diag.
, 10-10
Fr Pan Wr/Rd
, 10-9
FRAC N
, 10-22
Frac N Cont.
, 10-9
frac-N analog source
, 12-14
frac-N digital source
, 12-14
FRACN TUNE mode HI OUT
signal
, 7-27
FRACN TUNE ON OFF
, 10-17
fractional-N (digital)
, 10-38
Fractional-N Check
, 7-20
fractional-N frequency range
adjustment
, 3-40
fractional-N frequency range
adjustment sequence
, 3-55
fractional-N spur avoidance and
FM sideband adjustment
,
3-49
fractional-N spur avoidance and
FM sideband adjustment
sequence
, 3-55
frequency
accuracy adjustment
, 3-43
counter
, 1-3, 10-20
output in SRC tune mode
, 7-9
range and accuracy test
, 2-14,
2-96
range of fractional-N
adjustment
, 3-40
range, external source mode
test
, 2-17, 2-98
response test
, 2-36, 2-122
front panel
digital control
, 12-11
probe power voltages
, 5-17
processor, digital control of
,
12-11
troubleshooting
, 6-12
front panel key codes
, 6-13
functional group
fault isolation
, 4-10
theory of operation
, 12-5
fuse check
, 5-7
G
GPIB
addresses
, 4-8
cable
, 1-4
failures
, 6-19
mnemonic for service
, 10-1
service mnemonic definitions
,
10-42
system check
, 4-8
green LEDs
A15 preregulator (power supply
shutdown)
, 12-7
A8 post regulator
, 12-7
GSP digital control
, 12-12
H
H MB line
, 7-24
hardkeys
, 10-3
harmonic measurement accuracy
test
, 2-83
harmonics test
, 2-78
HB FLTR SW ON OFF
, 10-17
HI OUT signal in FRACN TUNE
mode
, 7-27
high band REF signal
, 7-15
high quality comb tooth at 3 GHz
,
7-26
high stability frequency reference
assembly replacement
, 14-50
high/low band transition
adjustment
, 3-47
adjustment sequence
, 3-55
how to
adjust
ADC offset correction
constants
, 3-15
analog bus correction
constants
, 3-9
cavity oscillator frequency
correction constants
, 3-26
fractional-N frequency range
,
3-40
fractional-N spur avoidance
and FM sideband
, 3-49
frequency accuracy
, 3-43
high/low band transition
, 3-47
IF amplifier correction
constants
, 3-14
option numbers correction
constants
, 3-32
RF output power correction
constants
, 3-11
sampler magnitude correction
constants
, 3-16
serial number correction
constants
, 3-31
source default correction
constants
, 3-7
source pretune correction
constants
, 3-10
source pretune default
correction constants
, 3-8
source spur avoidance
tracking
, 3-52
the analyzer
, 3-1
the analyzer using sequences
,
3-55
backup the EEPROM disk
, 3-34
check display intensity
, 6-7
clean connectors
, 1-7
identify the faulty functional
group
, 4-10