Alcatel-Lucent 7342 - Outdoor ONT Connections and Components

7 — ONT equipment layout
7-14 July 2008 Alcatel-Lucent 7342 ISAM FTTU ONT R04.05.06
ONT Product Information Manual Edition 01 3FE 51892 AAAA TCZZA
Table 7-9 I-211M-G ONT connectors
Notes
(1)
The I-211M-G ONT uses RJ-11 and RJ-45 connectors that are not gel-filled.
(2)
The 3FE 51307 BA and BB variants of the I-211M-G ONT do not include IDC connectors.
7.5 Outdoor ONT connections and components
The following section describes the different single residence outdoor ONT models
and connections.
Outdoor ONTs are externally hardened for outdoor deployment. A tamper-resistant
mechanical fitting prevents unauthorized entry. There are two inner covers and an
outer cover that seals the enclosure. Under the outer cover, a nested inner cover
prevents access to fiber and power terminals, but allows an unobstructed view of
status LEDs, POTS, Ethernet, and RF video connections. The connections are
accessible without opening the fiber and power protection cover.
Figure 7-10 shows the O-421E outdoor ONT with the inner cover closed as well as
cable entry points and enclosure locking mechanisms.
Connectors Description
POTS connectors RJ-11 connectors for POTS connection with optional IDC connectors
(1) (2)
Data and IP video
connectors
RJ-45 connectors for 10/100/1000BASE-T for Ethernet connection with
optional IDC-type connectors
(1) (2)
Type F connector Type F connector that supports RG-6, and series 7 coax cables for CATV and
MoCA connection
PON optical
connectors
SC/APC or OptiTap connector or SC/SC APC adaptor for GPON connection
Power connectors Internal power and alarm IDC with optional auxiliary battery pack
Alarm connectors Internal power and alarm IDC