Alcatel-Lucent 7342 - Figure 7-28 Connectors on a B-8211-A

7 — ONT equipment layout
Alcatel-Lucent 7342 ISAM FTTU ONT R04.05.06 July 2008 7-37
3FE 51892 AAAA TCZZA Edition 01 ONT Product Information Manual
Figure 7-28 Connectors on a B-8211-A
Table 7-19 describes the business ONT physical connections.
Table 7-19 Business ONT connections
(Optional)
Class 1 power and
fiber conduit box
TELCO ACCESS
PWR
CRAFT
LINE
1
BTRY
FAIL
VIDEO
DATA
NTWK
MGMT
INTF
POTS
LINE
2
LINE
3
LINE
4
LINE
5
LINE
6
LINE
7
LINE
8
BLK
TRTRTRTR TRTRTRTR
1
2
3
4
T
R
5
6
7
INPUT RATING: DC
45V 55V 1.0A
THIS DEVICE IS INTEDED TO BE
ATTACHED TO A RECEIVER THAT IS
NOT USED TO RECEIVE OVER-THE0AIR
BROADCAST SIGNALS. CONNECTION OF
THIS DEVICE IN ANY OTHER FASHION
MAY CAUSE HARMFUL INTERFERENCE
TO RADIO COMMUNICATION AND IS
IN VIOLATION OF THE FCC RULES,
PART 15.
VIDEO
TELCO ACCESS
SF EQPT
DS1
DS2
1
SF EQPT
2
1
MODE LINK
ETHERNET
Craft port
Power and alarm
connector
Ethernet por
t
(RJ-45)
DS1/E1 port
1
(RJ-48C)
DS1/E1 port
2
(RJ-48C)
GND
POTS ports
(RJ-11)
Fiber storage
tray
SC/APC fiber
connector
POTS screw
type block
F-type
coaxial
1888
5
Connection Function
Craft port
(1)
This connection is used for the management of the business ONT unit.
Data, IP video, and
VoIP connection
This connection is provided through the Ethernet RJ-45 connector or the IDC
type connector for connection to 4-pair Ethernet lines. One Ethernet
connection is supported, which can carry data, VoIP, and overlaid IP video
services.
DS1/E1 connection The RJ-48C DS1/E1 connection support structured, unstructured, and
fractional DS1/E1.
PON optical
connection
This connection is provided through an SC/APC connector or an OptiTap/APC
connector for the physical interface to the PON.
POTS connection This connection is provided through RJ-11 ports and either screw-down
terminals or IDC connectors, depending upon the model.
(1 of 2)