43 — PowerShield CP50B48 UPS unit data sheet
Alcatel-Lucent 7342 ISAM FTTU ONT R04.05.06 July 2008 43-3
3FE 51892 AAAA TCZZA Edition 01 ONT Product Information Manual
43.3 General description
The APC UPS is mounted either inside or outside a customer premises. It provides
backup battery power for lifeline POTS service in the business ONT, depending on
environmental conditions and load. It converts 87 V ac to 264 V ac input (50/60 Hz)
to 46 V dc to 52 V dc (50 W) output and serves as a temporary backup in case of
power loss.
Alarm outputs are available on the UPS to monitor the operational status of the
backup battery. The UPS indicates its status to the craft person with LEDs and to the
business ONT by a signal return connection. The business ONT can communicate
the UPS status upstream to the P-OLT.
43.4 Operating modes
There are four operating modes as follows:
• Normal: Under normal operating conditions, the green LED light is on and the red
LED light is off. The load receives its power from the utility and battery charge
is maintained.
• On-Battery: During a commercial utility outage, the UPS supplies the load from
battery power. When operating in On-Battery mode, the AC Present LED light is
yellow.
• Low-Battery Shutdown: When the UPS operates on battery power for extended
periods, the battery charge is depleted and the UPS shuts down. In this case, all
LED lights are off. The UPS remains in the Off condition until utility power is
restored and no battery current is drawn.
• Overload Condition: When the unit shuts down due to an overload, the unit
automatically restarts after 5 s.
43.5 Status LEDs
Three indicator LEDs are present on the front of the UPS. Each LED is labeled with
an icon. These icons, with their meanings, are shown in Figure 43-1. The operating
mode can be determined by the state of these LEDs; see Table 43-2.
Figure 43-1 UPS icons and meanings
Note — The battery recharges to at least 90% of full capacity in
48 hours.
To Next Page
Loading...