Alcatel-Lucent 7342 - Connections

37 — CyberPower CyberShield CS 24 UPS unit data sheet
37-4 July 2008 Alcatel-Lucent 7342 ISAM FTTU ONT R04.05.06
ONT Product Information Manual Edition 01 3FE 51892 AAAA TCZZA
The UPS is also equipped with a switch, located on the back of the unit, that when
activated emits an alarm under certain conditions. If you want to enable the switch,
insert a paper clip or other object with a narrow point into the hole and press the
button.
Table 37-4 describes the function of the Buzzer On/Off switch.
Table 37-4 Buzzer On/Off switch
37.6 Connections
The UPS has the following:
• input connector: NEMA 1-15P plug
• cord length: 8.0 ft (2.44 m)
• output connector: Phoenix QC 0.5/2-ST-3.81 LC RD/BK IDC connector
Table 37-5 describes the UPS output pinouts.
Table 37-5 CyberShield CS 24 power wiring chart
BATTERY MISSING The battery-missing alarm indicates that no battery is
detected.
LOW BATTERY The low-battery alarm indicates that the battery charger
has fallen below 45% capacity when operating from the
battery.
Setting Description
ON The alarm buzzer emits a long beep in response to a utility
failure or short beep when the battery is low on power.
OFF The alarm will not sound.
The default setting.
Signal Description
(2 of 2)
Wire color Signal
Red (RED) + 12 V
Black (BLK) - 12 V RTN
Green (GRN) SIG RTN
Slate (SLT) ON BATTERY
Brown (BRN) REPLACE BATTERY
Blue (BLU) BATTERY MISSING
Orange (ORN) LOW BATTERY