Alcatel-Lucent 7342 - Modular ONT and Plug-In Unit Connections and Components

7 — ONT equipment layout
Alcatel-Lucent 7342 ISAM FTTU ONT R04.05.06 July 2008 7-29
3FE 51892 AAAA TCZZA Edition 01 ONT Product Information Manual
Figure 7-21 Physical connections on an O-00240V-A MDU ONT
Table 7-17 describes the O-00240V-A MDU ONT physical connections.
Table 7-17 O-00240V-A MDU ONT physical connections
7.8 Modular ONT and plug-in unit connections and components
The following section describes the modular ONT and plug-in unit connections.
Figure 7-22 and Table 7-18 describe the modular ONT physical connections.
7352 ISAM FTTB ONT
CRAFT ETHERNET
SAVE
DATA
PWR BAT DATA
FAIL NTWK INT
MGMT
VDSL
GPON
1965
5
Ground lug
Environmental
and door alarm
connector
UPS alarm
connector
Power and
return connector
Ethernet
port
VDSL2
connector
Craft port Fiber optic connector
Connection Description
Ground lug (or wire
terminal)
The interface is a terminal to which a ground wire (X AWG) connects.
UPS alarm connector A 5-position IDC connector that provides support for UPS alarms.
Environmental and door
alarm connector
A 8-position IDC connector that provides up to three customer defined
environmental alarms and one door alarm for the O-00240V-A MDU ONT.
Power and return
connector
A 2-position IDC connector that provides -48 V/-60V power and return.
Craft port The craft port is a right-angled RS-232 serial port that can be accessed
with a male DB-9 connector.
Ethernet port The interface is an Ethernet RJ-45 port that supports 10/100BASE-T
Ethernet connections.
See the Planning and Ordering Guide for more information about
ordering Ethernet cables. These cables must be ordered separately.
VDSL2 connector The interface is a RJ-21 connector with 50 positions of which 48 support
up to 24 VDSL2 lines. The cable is not included with the ONT and must
be ordered separately.
Fiber optic connector An SC/APC fiber optic connector terminates a fiber optic connection
from the P-OLT.