Alcatel-Lucent 7342 - Figure 7-30 Connectors on an O-820 G-D SOHO Outdoor ONT

7 — ONT equipment layout
Alcatel-Lucent 7342 ISAM FTTU ONT R04.05.06 July 2008 7-39
3FE 51892 AAAA TCZZA Edition 01 ONT Product Information Manual
Figure 7-30 shows the O-820G-D small office home office (SOHO) outdoor ONT
physical connections.
Figure 7-30 Connectors on an O-820G-D SOHO outdoor ONT
Table 7-20 describes the SOHO ONT physical connections.
Table 7-20 SOHO ONT connections
THIS DEVICE IS INTEDED TO BE
ATTACHED TO A RECEIVER THAT IS
NOT USED TO RECEIVE OVER-THE0AIR
BROADCAST SIGNALS. CONNECTION OF
THIS DEVICE IN ANY OTHER FASHION
MAY CAUSE HARMFUL INTERFERENCE
TO RADIO COMMUNICATION AND IS
IN VIOLATION OF THE FCC RULES,
PART 15.
VIDEO
TELCO ACCESS
PWR
CRAFT
LINE
1
BTRY
FAIL
VIDEO
DATA
NTWK
MGMT
INTF
POTS
LINE
2
LINE
3
LINE
4
LINE
5
LINE
6
LINE
7
LINE
8
BLK
INPUT RATING: DC
45V 55V 1.0A
TELCO ACCESS
1
MODE LINK
ETHERNET
2
MODE LINK
ETHERNET
Craft port
Power and alarm
connector
Ethernet 1
(RJ-45)
POTS ports (RJ-1
1)
SC/APC fiber
connector
POTS IDC
connectors (5-8)
1895
7
TRTRTRTR TRTRTRTR TRTRTRTR TRTRTRTRTRTRTRTR TRTRTRTR
Ethernet 1
IDC connectors
Ethernet 2
IDC connectors
POTS IDC
connectors (1-4)
TRTRTRTR TRTRTRTR
Ethernet 2
(RJ-45)
GND
Connection Function
Craft port
(1)
This connection is used for the management of the business ONT unit.
Data, IP video, and
VoIP connection
This connection is provided through the Ethernet RJ-45 connector or the IDC
type connector for connection to 4-pair Ethernet lines. One Ethernet
connection is supported, which can carry data, VoIP, and overlaid IP video
services.
PON optical
connection
This connection is provided through an SC/APC connector or an OptiTap/APC
connector for the physical interface to the PON.
POTS connection This connection is provided through RJ-11 ports and either screw-down
terminals or IDC connectors, depending upon the model.
(1 of 2)