EasyManua.ls Logo

Alcatel-Lucent 7342 - Identification; 43 - Powershield CP50 B48 UPS Unit Data Sheet

Alcatel-Lucent 7342
448 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
20 — I-211M-G unit data sheet
20-2 July 2008 Alcatel-Lucent 7342 ISAM FTTU ONT R04.05.06
ONT Product Information Manual Edition 01 3FE 51892 AAAA TCZZA
20.1 Identification
Table 20-1 provides identification information about the I-211M-G ONT.
Table 20-1 Identification of indoor ONTs
Note
(1)
See the 7342 ISAM FTTU ONT Planning and Ordering guide for product identification information.
20.2 General description
The indoor ONT provides the subscriber interface for the 7342 ISAM FTTU. The
ONT terminates the PON interface and converts it to user interfaces that directly
connect to subscriber devices. The ONT is compatible with all existing subscriber
equipment, including analog phones with both tone and rotary dial capabilities,
cordless phones, modems, fax machines, and caller ID boxes (Type I, Type II, and
Type III).
The I-211M-G ONT meets or exceeds the specifications of MoCA 1.0 as determined
by the Multimedia over Coax Alliance (MoCA).
Part number Mnemonic
(1)
Description CLEI CPR ECI/Bar
code
3FE 51307 AB
(customer-spec
ific logo on
door)
I-211M-G GPON I-series ONT unit, version G, 2 POTS
interfaces, 1 10/100/1000 BASE-T Gigabit
Ethernet interface, 1 RF video, and 1 MoCA
interface.
The 3FE 51307 BB comes equipped with a
fiber strength member clamp.
This part number provides an installation kit
that includes an skirt, 20 feet (6.1 m)
cabling, and fiber slack storage tray,
suitable for an ‘on wall’ installation.
All variants use a later release of MoCA.
BVM5200CRA 211742 456782
3FE 51307 BB
(without
customer-speci
fic logo on
door)
N/A N/A N/A
3EM 22705 AA ‘in wall’
installation
kit
Installation kit required for the I-211M-G
ONT to be mounted inside a cabinet, which
can then be mounted between the studs in
a SFU, also known as an ‘in wall’
installation.
This installation kit provides an OptiTap to
SC adaptor connector and push rivets for
installation inside a Suttle cabinet.
N/A N/A N/A
UPS (included
with the ONTs
listed above
and not
orderable
separately)
The Delta 38 W, 12 V dc OPSU/BBU, see
the Delta OPSU/BBU unit data sheet.
N/A N/A N/A
PX12072
PXL12072
PWL12V7
Batteries supplied by GS Yuasa International
Ltd. approved for use with the I-211M-D
ONT.
N/A N/A N/A

Table of Contents