Alcatel-Lucent 7342 - Status Reporting

11 — ONT statistics and performance monitoring
Alcatel-Lucent 7342 ISAM FTTU ONT R04.05.06 July 2008 11-11
3FE 51892 AAAA TCZZA Edition 01 ONT Product Information Manual
TCA provisioning
Performance monitoring counters are provisioned using either a TL1 or an EMS
management session with the P-OLT. TCA is disabled by default. The procedure
required for provisioning TCAs varies, depending on the type of interface or service
you are monitoring.
• To enable TCA for VDSL2, you must first create a VDSL2 TCA profile, which
specifies the threshold values for ES. SES and USA counters. The name and ID
of the profile must then be assigned to a particular VDSL2 interface. Finally,
enable TCA using the TL1 ONTVDSL performance monitoring provisioning
commands or set the appropriate fields in the EMS.
• To enable TCA for all other counters, you do not need to create a profile. You
only need to set the threshold value using TL1 or an EMS. After the threshold is
set, enable TCA using the appropriate TL1 performance monitoring provisioning
commands or set the appropriate fields in the EMS.
For configuration information, see the 7342 ISAM FTTU Operations and
Maintenance Procedures Guide using TL1 and CLI manual.
Status reporting
Status reports are available for the following:
• 802.1 end-user authentication
• 802.1 operator authentication
• iBridges
• ONT Ethernet ports
• ONT MoCA ports
• ONT optical link status levels
• ONT VDSL2 channels and ports
See the 7342 ISAM FTTU Operations and Maintenance Procedures Guide using
TL1 and CLI document for statistical parameters that are displayed in status reports.