Chapter 2. Setting Up 9500 MXC CT
Vol. IV-2-4 Alcatel-Lucent
Ethernet DHCP connection
This is an option for all 9500 MXC radios.
A DHCP connection does not require knowledge of the Node/Terminal IP
address. DHCP connection has the following requirements:
• The radio must be enabled as a DHCP server.
• Your PC must have DHCP enabled (to obtain an IP address automatically).
Next Step:
• Setting Up A DHCP Ethernet 9500 MXC CT Connection on page 2-9.
V.24
A V.24 connection applies to all 9500 MXC radios.
A 24 connection does not require knowledge of the Node/Terminal IP address.
• A V.24 cable is included in the installation kit of all Nodes/Terminals.
• V.24 is normally used to login to a new Node/Terminal. Once configured
with an IP address, an Ethernet connection should subsequently be used
because of its faster connection/running speed.
Next Step:
• Setting Up 9500 MXC CT Connection Using V.24 on page 2-11.
PC-to-9500 MXC Connection
Option
Description
To Next Page
Loading...
