Chapter 2. Outdoor Installations
Vol. III-2-32 Alcatel-Lucent
Installing a Suppressor With a Support Bracket
This procedure describes the installation process using the original suppressor
support bracket, which only supports a ‘vertical’ orientation of the suppressor.
The new universal support bracket supports both a vertical and horizontal
orientation. For the horizontal option, omit the right-angle Type N connector in
the following procedure.
Procedure:
1. Attach the right-angle Type N connector (supplied in the ODU installation
kit) to the suppressor.
2. Set in the alignment shown and firmly hand-tighten.
3. Weatherproof the connection between the right-angle connector and
suppressor using the self-amalgamating tape supplied in the suppressor
installation kit.
Refer to Self Amalgamating Tape on page 2-39.
For ease of installation, complete steps 1 to 13 on the ground.
To Next Page
Loading...
