Chapter 2. Setting Up 9500 MXC CT
Vol. IV-2-10 Alcatel-Lucent
DHCP Server function enabled, refer to:
• DHCP Ethernet Access Requirements on page 2-10
• Setting Up Your TCP/IP Properties for DHCP on page 2-10
DHCP Ethernet Access Requirements
A successful DHCP Ethernet connection from a CT PC requires the following:
• An industry-standard 10Base-T or 10/100Base-T LAN card installed on your
PC.
• DHCP enabled within the TCP/IP Properties window on your PC.
• DHCP server enabled on the 9500 MXC radio you are connecting to.
Setting Up Your TCP/IP Properties for DHCP
Introduction
Your CT PC must be configured to obtain an IP address automatically, which is
set within the Local Area Connection window on your PC.
Procedure
This procedure is based on a PC running Windows 2000 PC; there may be small
differences with other versions of Windows.
1. Click on the LAN (network connection) icon in the System Tray, located in
the lower right corner of your PC screen.
Or, from the Control Panel of your PC, select
Network and Dial-up
Connections
> Local Area Connection.
The Local Area Connection Status window is displayed.
2. Click
Properties.
3. Select
Internet Protocol (TCP/IP).
4. Ensure its associated box is ticked.
The DHCP server function is configured in the Configuration > Networking
screen. Refer to DHCP Server Function on page 10-13, Volume IV, Chapter 11.
LAN Icon
To Next Page
Loading...
