AudioCodes Mediant 500L MSBR

User's Manual 37. SBC Manipulations
Version 6.8 579 Mediant 500L MSBR
Parameter Description
pulationPurpose]

[1] Routing input only = Inbound manipulations affect the routing
input only, retaining the original source and destination number.
 [2] Shared Line = Used for the Shared-Line Appearance
feature. This manipulation is for registration requests to change
the destination number of the secondary extension numbers to
the primary extension. For more information, see ''BroadSoft's
Shared Phone Line Call Appearance for SBC Survivability'' on
page 536.
Source IP Group ID
CLI: src-ip-group-id
[IPInboundManipulation_SrcI
pGroup]
Defines the IP Group from where the incoming INVITE is received.
The default is -1 (i.e., any IP Group).
Source Username Prefix
CLI: src-user-name-prefix
[IPInboundManipulation_SrcU
sernamePrefix]
Defines the prefix of the source SIP URI user name (usually in the
From header).
The default is the asterisk (*) symbol (i.e., any source username
prefix).
Note: The prefix can be a single digit or a range of digits. For
available notations, see ''Dialing Plan Notation for Routing and
Manipulation'' on page 777.
Source Host
CLI: src-host
[IPInboundManipulation_SrcH
ost]
Defines the source SIP URI host name - full name (usually in the
From header).
The default is the asterisk (*) symbol (i.e., any host name).
Destination Username Prefix
CLI: dst-user-name-prefix
[IPInboundManipulation_Dest
UsernamePrefix]
Defines the prefix of the destination SIP URI user name, typically
located in the Request-URI and To headers.
The default is the asterisk (*) symbol (i.e., any destination
username prefix).
Note: The prefix can be a single digit or a range of digits. For
available notations, see ''Dialing Plan Notation for Routing and
Manipulation'' on page 777.
Destination Host
CLI: dst-host
[IPInboundManipulation_Dest
Host]
Defines the destination SIP URI host name - full name, typically
located in the Request-URI and To headers.
The default is the asterisk (*) symbol (i.e., any destination host
name).
Request Type
CLI: request-type
[IPInboundManipulation_Req
uestType]
Defines the SIP request type to which the manipulation rule is
applied.
 [0] All = (Default) All SIP messages.
 [1] INVITE = All SIP messages except REGISTER and
SUBSCRIBE.
 [2] REGISTER = Only REGISTER messages.
 [3] SUBSCRIBE = Only SUBSCRIBE messages.
 [4] INVITE and REGISTER = All SIP messages except
SUBSCRIBE.
 [5] INVITE and SUBSCRIBE = All SIP messages except
REGISTER.
Manipulated URI
CLI: manipulated-uri
[IPInboundManipulation_Mani
pulatedURI]
Determines whether the source or destination SIP URI user part is
manipulated.
 [0] Source = (Default) Manipulation is done on the source SIP
URI user part.

[1] Destination = Manipulation is done on the destination SIP