AudioCodes Mediant 500L MSBR

User's Manual 37. SBC Manipulations
Version 6.8 583 Mediant 500L MSBR
Parameter Description
Source IP Group ID
CLI: src-ip-group-id
[IPOutboundManipulation_SrcIPG
roupID]
Defines the IP Group from where the INVITE is received.
The default value is -1 (i.e., any IP Group).
Destination IP Group ID
CLI: dst-ip-group-id
[IPOutboundManipulation_DestIP
GroupID]
Defines the IP Group to where the INVITE is to be sent.
The default value is -1 (i.e., any IP Group).
Source Username Prefix
CLI: src-user-name-prefix
[IPOutboundManipulation_SrcUse
rnamePrefix]
Defines the prefix of the source SIP URI user name, typically
used in the SIP From header.
The default value is the asterisk (*) symbol (i.e., any source
username prefix). The prefix can be a single digit or a range of
digits. For available notations, see ''Dialing Plan Notation for
Routing and Manipulation'' on page 777.
Source Host
CLI: src-host
[IPOutboundManipulation_SrcHos
t]
Defines the source SIP URI host name - full name, typically in
the From header.
The default value is the asterisk (*) symbol (i.e., any source
host name).
Destination Username Prefix
CLI: dst-user-name-prefix
[IPOutboundManipulation_DestUs
ernamePrefix]
Defines the prefix of the destination SIP URI user name,
typically located in the Request-URI and To headers.
The default value is the asterisk (*) symbol (i.e., any
destination username prefix). The prefix can be a single digit
or a range of digits. For available notations, see ''Dialing Plan
Notation for Routing and Manipulation'' on page 777.
Destination Host
CLI: dst-host
[IPOutboundManipulation_DestHo
st]
Defines the destination SIP URI host name - full name,
typically located in the Request-URI and To headers.
The default value is the asterisk (*) symbol (i.e., any
destination host name).
Calling Name Prefix
CLI: calling-name-prefix
[IPOutboundManipulation_Calling
NamePrefix]
Defines the prefix of the calling name (caller ID). The calling
name appears in the SIP From header.
The valid value is a string of up to 37 characters. By default,
no prefix is defined.
Message Condition
CLI: message-condition
[IPOutboundManipulation_Messa
geCondition]
Assigns a Message Condition rule as a matching
characteristic. Message Condition rules define required SIP
message formats. For configuring Message Condition rules,
see ''Configuring Message Condition Rules'' on page 562.
Request Type
CLI: request-type
[IPOutboundManipulation_Reques
tType]
Defines the SIP request type to which the manipulation rule is
applied.
 [0] All = (Default) all SIP messages.
 [1] INVITE = All SIP messages except REGISTER and
SUBSCRIBE.
 [2] REGISTER = Only SIP REGISTER messages.
 [3] SUBSCRIBE = Only SIP SUBSCRIBE messages.
 [4] INVITE and REGISTER = All SIP messages except
SUBSCRIBE.
 [5] INVITE and SUBSCRIBE = All SIP messages except
REGISTER.
ReRoute IP Group ID
CLI: re-route-ip-group-id
Defines the IP Group that initiated (sent) the SIP redirect
response (e.g., 3xx) or REFER message. This parameter is