User's Manual 988 Document #: LTRT-10466
Mediant 500L MSBR
Parameter Description
Web: ENUM Resolution
CLI: enum-service-domain
[EnumService]
Defines the ENUM service for translating telephone numbers
to IP addresses or domain names (FQDN), for example,
e164.arpa, e164.customer.net, or NRENum.net.
The valid value is a string of up to 50 characters. The default
is "e164.arpa".
Note: For the Gateway / IP-to-IP application, ENUM-based
routing is configured in the Outbound IP Routing table using
the "ENUM" string value as the destination address to
denote this parameter's value.
Web: Use Routing Table for Host
Names and Profiles
EMS: Use Routing Table For Host
Names
CLI: rte-tbl-4-host-names
[AlwaysUseRouteTable]
Determines whether to use the device's routing table to
obtain the URI host name and optionally, an IP profile (per
call) even if a Proxy server is used.
[0] Disable = (Default) Don't use the Outbound IP
Routing table.
[1] Enable = Use the Outbound IP Routing table.
Notes:
This parameter appears only if the 'Use Default Proxy'
parameter is enabled.
The domain name is used instead of a Proxy name or IP
address in the INVITE SIP URI.
Web/EMS: Tel to IP Routing Mode
CLI: tel2ip-rte-mode
[RouteModeTel2IP]
For a description of this parameter, see ''Configuring
Outbound IP Routing'' on page 405.
Outbound IP Routing Table
Web: Outbound IP Routing Table
EMS: SIP Routing > Tel to IP
CLI: configure voip > gw routing tel2ip-
routing
[Prefix]
This table parameter configures outbound IP routing rules
for routing Tel-to-IP and IP-to-IP calls.
The format of this parameter is as follows:
[PREFIX]
FORMAT PREFIX_Index = PREFIX_RouteName,
PREFIX_DestinationPrefix, PREFIX_DestAddress,
PREFIX_SourcePrefix, PREFIX_ProfileId,
PREFIX_MeteringCode, PREFIX_DestPort,
PREFIX_SrcIPGroupID, PREFIX_DestHostPrefix,
PREFIX_DestIPGroupID, PREFIX_SrcHostPrefix,
PREFIX_TransportType, PREFIX_SrcTrunkGroupID,
PREFIX_DestSRD, PREFIX_CostGroup,
PREFIX_ForkingGroup, PREFIX_CallSetupRulesSetId;
[\PREFIX]
For a detailed description of this table, see ''Configuring
Outbound IP Routing'' on page 405.
Inbound IP Routing Table
Web: Inbound IP Routing Table
EMS: SIP Routing > IP to Hunt
CLI: configure voip > gw routing ip2tel-
routing
[PSTNPrefix]
This table parameter configures the routing of IP-to-Trunk
Groups (or inbound IP Groups).
The format of the ini file table parameter is as follows:
[PSTNPrefix]
FORMAT PstnPrefix_Index = PstnPrefix_RouteName,
PstnPrefix_DestPrefix, PstnPrefix_TrunkGroupId,
PstnPrefix_SourcePrefix, PstnPrefix_SourceAddress,
PstnPrefix_ProfileId, PstnPrefix_SrcIPGroupID,
PstnPrefix_DestHostPrefix, PstnPrefix_SrcHostPrefix,
PstnPrefix_SrcSRDID, PstnPrefix_TrunkId,