AudioCodes Mediant 600 - Page 112

SIP User's Manual 112 Document #: LTRT-83310
Mediant 600 & Mediant 1000
Application Traffic / Network Types Class-of-Service (Priority)
(EnableNTPasOAM):
 OAMP
 Control

Control: Premium control
 Management: Bronze
NFS NFSServers_VlanType in the
NFSServers table
Gold
10.3.1.1.3.5 Assigning NTP Services to Application Types
NTP applications can be associated with different application types (OAMP or Control) in
different setups. The table below describes the parameter for configuring this:
Table 10-6: Application Type Parameters
Parameter Description
EnableNTPasOAM
Determines the application type for NTP services.
 [1] = OAMP (default)
 [0] = Control.
Note: For this parameter to take effect, a device reset is required.
10.3.1.1.4 Multiple Interface Table Configuration Summary and Guidelines
Multiple Interface table configuration must adhere to the following rules:

Up to 16 different interfaces may be defined.

The indices used must be in the range between 0 and 15.

Each interface must have its own subnet. Defining two interfaces with addresses in
the same subnet (i.e. two interfaces with 192.168.0.1/16 and 192.168.100.1/16) is
illegal.

Subnets in different interfaces must not be overlapping in any way (i.e. defining two
interfaces with 10.0.0.1/8 and 10.50.10.1/24 is invalid). Each interface must have its
own address space.

The Prefix Length replaces the dotted decimal Subnet Mask presentation. This column
must have a value of 0-30 for IPv4 interfaces.

Only one OAMP interface must be configured, and this must be of address type IPv4.
This OAMP interface can be combined with Media and Control interfaces.

At least one IPv4 interface with CONTROL "Application Types" must be configured.

At least one IPv4 interface with MEDIA "Application Types" must be configured.

The application types may be mixed, for example:
• One IPv4 interface with "Application Types" OAMP, MEDIA & CONTROL (without
VLANs).
• One IPv4 interface with "Application Types" OAMP, one other or more IPv4
interfaces with "Application Types" CONTROL, and one or more IPv4 interfaces
with "Application Types" MEDIA (with VLANs).
• One IPv4 interface with "Application Types" OAMP & MEDIA, one other or more
IPv4 interfaces with "Application Types" MEDIA & CONTROL.
• Other configurations are also possible while keeping to the above-mentioned rule.

Each network interface may be defined with a default gateway. This default gateway
address must be in the same subnet as the associated interface. Additional routing