Version 6.4 253 March 2012
SIP User's Manual 18. GW and IP to IP
Parameter Description
Note: For configuring Tel Profiles, refer to the parameter TelProfile.
18.2.2 Configuring Trunk Group Settings
The Trunk Group Settings page allows you to configure the settings of up to 120 Trunk
Groups. These Trunk Groups are configured in the Trunk Group Table page (see
Configuring Trunk Group Table on page 251).
This page allows you to select the method for which IP-to-Tel calls are assigned to
channels within each Trunk Group. If no method is selected for a specific Trunk Group, the
setting of the global parameter, ChannelSelectMode takes effect. In addition, this page
defines the method for registering Trunk Groups to selected Serving IP Group IDs (if
defined).
Note: You can also configure the Trunk Group Settings table using the ini file table
parameter TrunkGroupSettings (see 'Number Manipulation Parameters' on
page 750).
To configure the Trunk Group Settings table:
1. Open the Trunk Group Settings page (Configuration tab > VoIP menu > GW and IP
to IP submenu > Trunk Group submenu > Trunk Group Settings).
2. From the 'Index' drop-down list, select the range of entries that you want to edit.
3. Configure the Trunk Group according to the table below.
4. Click Submit to apply your changes.
5. To save the changes to flash memory, see 'Saving Configuration' on page 482.
An example is shown below of a REGISTER message for registering endpoint "101" using
registration Per Endpoint mode. The "SipGroupName" in the Request-URI is defined in the
IP Group table (see 'Configuring IP Groups' on page 195).
To Next Page
Loading...
