AudioCodes Mediant 600 - Gateway and IP-To-IP Parameters; Fax and Modem Parameters

Version 6.4 639 March 2012
SIP User's Manual A. Configuration Parameters Reference
A.12 Gateway and IP-to-IP Parameters
A.12.1 Fax and Modem Parameters
The fax and modem parameters are described in the table below.
Table A-37: Fax and Modem Parameters
Parameter Description
Web: Fax Transport Mode
EMS: Transport Mode
[FaxTransportMode]
Determines the fax transport mode used by the device.
 [0] Disable = transparent mode
 [1] T.38 Relay (default)
 [2] Bypass
 [3] Events Only
Note:
This parameter is overridden by the parameter IsFaxUsed. If the
parameter IsFaxUsed is set to 1 (T.38 Relay) or 3 (Fax Fallback), then
FaxTransportMode is always set to 1 (T.38 relay).
Web: V.21 Modem Transport
Type
EMS: V21 Transport
[V21ModemTransportType
]
Determines the V.21 modem transport type.
 [0] Disable = Disable (Transparent) - default
 [1] Enable Relay = N/A
 [2] Enable Bypass.
 [3] Events Only = Transparent with Events
Note: This parameter can also be configured per IP Profile, using the
IPProfile parameter (see 'Configuring IP Profiles' on page 219).
Web: V.22 Modem Transport
Type
EMS: V22 Transport
[V22ModemTransportType
]
Determines the V.22 modem transport type.
 [0] Disable = Disable (Transparent)
 [1] Enable Relay = N/A
 [2] Enable Bypass = (default)
 [3] Events Only = Transparent with Events
Note: This parameter can also be configured per IP Profile, using the
IPProfile parameter (see 'Configuring IP Profiles' on page 219).
Web: V.23 Modem Transport
Type
EMS: V23 Transport
[V23ModemTransportType
]
Determines the V.23 modem transport type.
 [0] Disable = Disable (Transparent)
 [1] Enable Relay = N/A
 [2] Enable Bypass = (default)
 [3] Events Only = Transparent with Events
Note: This parameter can also be configured per IP Profile, using the
IPProfile parameter (see 'Configuring IP Profiles' on page 219).
Web: V.32 Modem Transport
Type
EMS: V32 Transport
[V32ModemTransportType
]
Determines the V.32 modem transport type.
 [0] Disable = Disable (Transparent)
 [1] Enable Relay = N/A
 [2] Enable Bypass = (default)
 [3] Events Only = Transparent with Events
Notes:
 This parameter applies only to V.32 and V.32bis modems.
 This parameter can also be configured per IP Profile, using the
IPProfile parameter (see 'Configuring IP Profiles' on page 219).