Version 6.4 165 March 2012
SIP User's Manual 12. Media
The procedure below describes how to configure AGC using the Web interface:
To configure AGC using the Web interface:
1. Open the IPMedia Settings page (Configuration tab > VoIP menu > Media submenu
> IPMedia Settings).
2. Configure the following parameters:
• 'Enable AGC' (EnableAGC) - Enables the AGC mechanism.
• 'AGC Slope' (AGCGainSlope) - Determines the AGC convergence rate.
• 'AGC Redirection' (AGCRedirection) - Determines the AGC direction.
• 'AGC Target Energy' - Defines the signal energy value (dBm) that the AGC
attempts to attain.
3. Click Submit to apply your settings.
Note: The following additional parameters can be configured using either the EMS
or ini file:
• AGCMinGain - Defines the minimum gain (in dB) by the AGC when
activated
• AGCMaxGain - Defines the maximum gain (in dB) by the AGC when
activated.
• AGCDisableFastAdaptation - Enables the AGC Fast Adaptation mode
12.5 Configuring General Media Settings
The General Media Settings page allows you to configure various media parameters. For a
detailed description of the parameters appearing on this page, see 'Configuration
Parameters Reference' on page 541.
To configure general media parameters:
1. Open the General Media Settings page (Configuration tab > VoIP menu > Media
submenu > General Media Settings).
Figure 12-4: General Media Settings Page
2. Configure the parameters as required.
3. Click Submit to apply your changes.
4. To save the changes to flash memory, see 'Saving Configuration' on page 482.
To Next Page
Loading...
