SIP User's Manual 522 Document #: LTRT-83310
Mediant 600 & Mediant 1000
• Group Name: name of the served group, if applicable
• Status: indicates whether or not the group is registered ("Registered" or
"Unregistered")
BRI Phone Number Status:
• Phone Number: phone number of BRI endpoint
• Module/Port: module/port number of BRI endpoint
• Status: indicates whether or not the BRI endpoint is registered ("Registered" or
"Unregistered")
Note: The registration mode (i.e., per device, endpoint, account. or no registration)
is configured in the Trunk Group Settings table (see 'Configuring Trunk Group
Settings' on page 253) or using the TrunkGroupSettings ini file parameter.
28.7 Viewing IP Connectivity
The IP Connectivity page displays online, read-only network diagnostic connectivity
information on all destination IP addresses configured in the Outbound IP Routing Table
page (see 'Configuring Outbound IP Routing Table' on page 271).
Notes:
• This information is available only if the parameter 'Enable Alt Routing Tel
to IP'/AltRoutingTel2IPMode (see 'Configuring General Routing
Parameters' on page 270) is set to 1 (Enable) or 2 (Status Only).
• The information in columns 'Quality Status' and 'Quality Info' (per IP
address) is reset if two minutes elapse without a call to that destination.
To view IP connectivity information:
1. In the Routing General Parameters page, set the 'Enable Alt Routing Tel to IP'
parameter (AltRoutingTel2IPEnable) to Enable or Status Only.
2. Open the IP Connectivity page (Status & Diagnostics tab > VoIP Status menu > IP
Connectivity).
Figure 28-6: IP Connectivity Page
To Next Page
Loading...
