AudioCodes Mediant 600 - Voice Mail Parameters

Version 6.4 651 March 2012
SIP User's Manual A. Configuration Parameters Reference
A.12.4 Voice Mail Parameters
The voice mail parameters are described in the table below. For more information on the
Voice Mail application, refer to the CPE Configuration Guide for Voice Mail.
Table A-40: Voice Mail Parameters
Parameter Description
Web/EMS: Voice Mail
Interface
[VoiceMailInterface]
Enables the device's Voice Mail application and determines the
communication method used between the PBX and the device.
 [0] None (default)
 [1] DTMF
 [2] SMDI
 [3] QSIG
 [4] SETUP Only = For ISDN
 [5] MATRA/AASTRA QSIG
 [6] QSIG SIEMENS = QSIG MWI activate and deactivate
messages include Siemens Manufacturer Specific Information
(MSI)
 [7] IP2IP = The device's IP2IP application is used for interworking
between an IP Voice Mail server and the device. This is
implemented for sending unsolicited SIP NOTIFY messages
received from the Voice Mail server to an IP Group (configured
using the parameter NotificationIPGroupID).
 [8] ETSI = Euro ISDN, according to ETS 300 745-1 V1.2.4,
section 9.5.1.1. Enables MWI interworking from IP to Tel, typically
used for BRI phones.
Note: To disable voice mail per Trunk Group, you can use a Tel
Profile ID (using the TelProfile parameter) that is configured with the
EnableVoiceMailDelay parameter to disabled (0). This eliminates the
phenomenon of call delay on Trunks not implementing voice mail
when voice mail is enabled using this global parameter.
Web: Enable VoiceMail URI
EMS: Enable VMURI
[EnableVMURI]
Enables the interworking of target and cause for redirection from Tel
to IP and vice versa, according to RFC 4468.
 [0] Disable (default).
 [1] Enable.
Upon receipt of an ISDN Setup message with Redirect values, the
device maps the Redirect phone number to the SIP 'target'
parameter and the Redirect number reason to the SIP 'cause'
parameter in the Request-URI.
Redirecting Reason >> SIP Response Code
Unknown >> 404
User busy >> 486
No reply >> 408
Deflection >> 487/480
Unconditional >> 302
Others >> 302
If the device receives a Request-URI that includes a 'target' and
'cause' parameter, the 'target' is mapped to the Redirect phone
number and the 'cause' is mapped to the Redirect number reason.