Version 6.4 55 March 2012
SIP User's Manual 3. Web-Based Management
3. Click the Delete Scenario File button; a message box appears requesting
confirmation for deletion.
Figure 3-25: Message Box for Confirming Scenario Deletion
4. Click OK; the Scenario is deleted and the Scenario mode closes.
Note: You can also delete a Scenario using the following alternative methods:
• Loading an empty dat file (see 'Loading a Scenario to the Device' on
page 54).
• Loading an ini file with the ScenarioFileName parameter set to no value
(i.e., ScenarioFileName = "").
3.1.8.7 Quitting Scenario Mode
When you want to close the Scenario mode after using it for device configuration, follow
the procedure below:
To close the Scenario mode:
1. Simply click any tab (besides the Scenarios tab) on the Navigation bar, or click the
Cancel Scenarios button located at the bottom of the Navigation tree; a message box
appears, requesting you to confirm exiting Scenario mode, as shown below.
Figure 3-26: Confirmation Message Box for Exiting Scenario Mode
2. Click OK to exit.
To Next Page
Loading...
