AudioCodes Mediant 600 - Emergency Call Parameters

Version 6.4 671 March 2012
SIP User's Manual A. Configuration Parameters Reference
Parameter Description
channels. These channels are obtained from the IP media module
(i.e., MPM module). Note that the device must be housed with MPM
module(s) to support three-way conferencing. The device supports
up to five simultaneous, on-board three-way conference calls.
Notes:
 This parameter is applicable only to FXS and BRI interfaces.
 Three-way conferencing using an external conference server is
supported only by FXS interfaces.
 The on-board 3-way conference mode is not supported by Mediant
600.
 When using an external conference server (options [0] or [1]), a
conference call with up to six participants can be established.
Web: Establish
Conference Code
EMS: Establish Code
[ConferenceCode]
Defines the DTMF digit pattern, which upon detection generates the
conference call when three-way conferencing is enabled
(Enable3WayConference is set to 1).
The valid range is a 25-character string. The default is “!” (Hook-Flash).
Note: If the FlashKeysSequenceStyle parameter is set to 1 or 2, the
setting of the ConferenceCode parameter is overridden.
Web/EMS: Conference ID
[ConferenceID]
Defines the Conference Identification string (up to 16 characters). The
default value is 'conf'.
For 3-way conferencing using an external media server: The device
uses this identifier in the Conference-initiating INVITE that is sent to the
media server when Enable3WayConference is set to 1.
When using the Mediant 1000 Media Processing Module (MPM): To join
a conference, the INVITE URI must include the Conference ID string,
preceded by the number of the participants in the conference, and
terminated by a unique number.
For example: INVITE sip:4MyConference1234@10.1.10.10.
INVITE messages with the same URI join the same conference.
For example: ConferenceID = MyConference.
A.12.5.8 Emergency Call Parameters
The emergency call parameters are described in the table below.
Table A-48: Emergency Call Parameters
Parameter Description
EMS: Enable 911 PSAP
[Enable911PSAP]
Enables the support for the E911 DID protocol, according to the
Bellcore GR-350-CORE standard. This protocol defines signaling
between E911 Tandem Switches and the PSAP, using analog loop-
start lines. The FXO device can be installed instead of an E911
switch, connected directly to PSAP DID loop-start lines.
 [0] = Disable (default)
 [1] = Enable
Notes:
 This parameter is applicable only to FXO interfaces.
 This parameter can also be configured per Tel Profile, using the
TelProfile parameter.