AudioCodes Mediant 600 - Configuring RFC 2833 Payload

SIP User's Manual 156 Document #: LTRT-83310
Mediant 600 & Mediant 1000
12.3.3.2 Configuring RFC 2833 Payload
The procedure below describes how to configure the RFC 2833 payload using the Web
interface:
 To configure RFC 2833 payload using the Web interface:
1. Open the RTP/RTCP Settings page (Configuration tab > VoIP menu > Media
submenu > RTP/RTCP Settings).
2. Configure the following parameters:
• 'RTP Redundancy Depth' (RTPRedundancyDepth) - enables the device to
generate RFC 2198 redundant packets.
• 'Enable RTP Redundancy Negotiation' (EnableRTPRedundancyNegotiation) -
enables the device to included the RTP redundancy dynamic payload type in the
SDP, according to RFC 2198.
• 'RFC 2198 Payload Type' (RFC2198PayloadType) - defines the RTP redundancy
packet payload type according to RFC 2198.
• 'RFC 2833 TX Payload Type' (RFC2833TxPayloadType) - defines the Tx RFC
2833 DTMF relay dynamic payload type.
• 'RFC 2833 RX Payload Type' (RFC2833RxPayloadType) - defines the Rx RFC
2833 DTMF relay dynamic payload type.
3. Click Submit to apply your settings.