AudioCodes Mediant 600 - Configuring Server for Media Quality of Experience

SIP User's Manual 174 Document #: LTRT-83310
Mediant 600 & Mediant 1000
12.12 Configuring Server for Media Quality of Experience
The device can be configured to report voice (media) quality of experience to AudioCodes
Session Experience Manager (SEM) server, a plug-in for AudioCodes EMS. The reports
include real-time metrics of the quality of the actual call experience and processed by the
SEM.
 To configure QoE reporting of media:
1. Open the Media Quality of Experience page (Configuration tab > VoIP menu >
Media submenu > Media Quality of Experience).
Figure 12-8: Media Quality of Experience Page
2. Configure the parameters as required
• 'Server Ip' (QOEServerIP) - defines the IP address of the SEM server
• 'Port' (QOEPort) - defines the port of the SEM server
• 'Interface Name' (QOEInterfaceName) - defines the device's IP network interface
on which the SEM reports are sent
• 'Use Mos LQ' (QOEUseMosLQ) - defines the reported MOS type (listening or
conversational)
3. Click Submit to apply your changes.
4. To save the changes to flash memory, see 'Saving Configuration' on page 482.
Notes:
• To support this feature, the device must be installed with the relevant
Software Upgrade Feature Key.
• To configure the parameters to report and their thresholds per Media
Realm, see 'Quality of Experience per Media Realm' on page 171.
• For information on the SEM server, refer to the EMS User's Manual.