SIP User's Manual 376 Document #: LTRT-83310
Mediant 600 & Mediant 1000
c. Click Submit.
Figure 18-61: Defining IP Profile ID 1
6. Configure Profile ID #2 for the ITSP's:
a. From the 'Profile ID' drop-down list, select 2.
b. From the 'Coder Group' drop-down list, select Coder Group 2.
c. Click Submit.
18.9.2.8 Step 8: Configure Inbound IP Routing
This step defines how to configure the device for routing inbound (i.e., received) IP-to-IP
calls. The table in which this is configured uses the IP Groups that you defined in 'Step 5:
Configure the IP Groups' on page 370.
To configure inbound IP routing:
1. Open the Inbound IP Routing Table page (Configuration tab > VoIP menu > GW and
IP to IP submenu > Routing submenu > IP to Trunk Group Routing).
Figure 18-62: Defining Inbound IP Routing Rules
2. Index #1: routes calls with prefix 9 (i.e., local calls) dialed from IP-PBX users to the
local PSTN:
To Next Page
Loading...
