Part II
Management Tools
This part provides an overview of the various management tools that can be used to
configure the device and describes how to configure the management settings. The
following management tools can be used to configure the device:
Embedded HTTP/S-based Web server - see 'Web-based Management' on page 33
Command Line Interface (CLI) - see 'CLI-Based Management' on page 73
Configuration INI file - see 'INI File-Based Management' on page 83
AudioCodes Element Management System - see 'EMS-Based Management' on page
81
Simple Network Management Protocol (SNMP) browser software - see 'SNMP-Based
Management' on page 75
Notes:
• Some configuration settings can only be done using specific
management tools. For example, the ini file method provides many
parameters that are not supported in the Web interface.
• The CLI is used only for debugging.
• If you use AudioCodes BootP/TFTP utility to assign an IP address to the
device (see Using BootP/TFTP Server on page 26), you can also in the
same process load a firmware file (.cmp) and a configuration ini file (.ini
file). For more information on using the BootP/TFTP utility, refer to the
Product Reference Manual.
To Next Page
Loading...
