AudioCodes Mediant 600 - Mediant 600 & Mediant

SIP User's Manual 322 Document #: LTRT-83310
Mediant 600 & Mediant 1000
Notes:
• The Metering Tones page is available only for FXS interfaces.
• Charge Code rules can be assigned to routing rules in the Outbound IP
Routing Table (see 'Configuring Outbound IP Routing Table' on page
271). When a new call is established, the Outbound IP Routing Table' is
searched for the destination IP address. Once a route is located, the
Charge Code (configured for that route) is used to associate the route
with an entry in the Charge Codes table.
 To configure Metering tones:
1. Open the Metering Tones page (Configuration tab > VoIP menu > GW and IP to IP
submenu > Analog Gateway submenu > Metering Tones).
Figure 18-21: Metering Tones Page
2. Configure the Metering tones parameters as required. For a description of the
parameters appearing on this page, see 'Configuration Parameters Reference' on
page 541.
3. Click Submit to apply your changes.
4. To save the changes to the flash memory, see 'Saving Configuration' on page 482.
If you set the 'Generate Metering Tones' parameter to Internal Table, access the Charge
Codes Table page by clicking the Charge Codes Table button. For more information
on configuring the Charge Codes table, see 'Configuring Charge Codes Table' on page
323.