Version 6.4 135 March 2012
SIP User's Manual 11. Security
11.2 Configuring General Security Settings
The General Security Settings page is used to configure various security features. For a
description of the parameters appearing on this page, refer 'Configuration Parameters
Reference' on page 541.
To configure the general security parameters:
1. Open the General Security Settings page (Configuration tab > VoIP menu >
Security submenu > General Security Settings).
2. Configure the parameters as required.
3. Click Submit to apply your changes.
4. To save the changes to flash memory, refer to 'Saving Configuration' on page 482.
11.3 Configuring IP Security Proposal Table
The IP Security Proposals Table page is used to configure Internet Key Exchange (IKE)
with up to four proposal settings. Each proposal defines an encryption algorithm, an
authentication algorithm, and a Diffie-Hellman group identifier. The same set of proposals
applies to both Main mode and Quick mode.
Note: You can also configure the IP Security Proposals table using the ini file table
parameter IPsecProposalTable (see 'Security Parameters' on page 568).
To Next Page
Loading...
