SIP User's Manual 680 Document #: LTRT-83310
Mediant 600 & Mediant 1000
A.12.5.13 ISDN BRI Parameters
The automatic dialing upon off-hook parameters are described in the table below.
Table A-53: Automatic Dialing Parameters
Parameter Description
Web: ISDN Supp Services Table
[ISDNSuppServ]
This parameter table defines BRI phone extension numbers per BRI
port and configures various ISDN supplementary services per BRI
endpoint. The format of this parameter is as follows:
[ ISDNSuppServ ]
FORMAT ISDNSuppServ_Index = ISDNSuppServ_PhoneNumber,
ISDNSuppServ_Module, ISDNSuppServ_Port,
ISDNSuppServ_UserId, ISDNSuppServ_UserPassword,
ISDNSuppServ_CallerID, ISDNSuppServ_IsPresentationRestricted,
ISDNSuppServ_IsCallerIDEnabled;
[ \ISDNSuppServ ]
For example:
ISDNSuppServ 0 = 400, 1, 1, user, pass, callerid, 0, 1;
ISDNSuppServ 1 = 401, 1, 1, user, pass, callerid, 0, 1;
Notes:
For a description of each table parameter and for configuring the
table using the Web interface, see 'Configuring ISDN
Supplementary Services' on page 316.
For configuring ini file table parameters, see 'Configuring ini File
Table Parameters' on page 84.
BRI-to-SIP Supplementary Services Codes for Call Forward
Note: Upon receipt of an ISDN Facility message for call forward from the BRI phone, the device
sends a SIP INVITE to the softswitch with a user-defined code in the SIP To header, representing the
reason for the call forward. For more information on BRI call forwarding, see 'BRI Call Forwarding' on
page 300.
Call Forward Unconditional
[SuppServCodeCFU]
Defines the prefix code for activating Call Forward Unconditional sent
to the softswitch.
The valid value is a string. The default is an empty string.
Note: The string must be enclosed in single apostrophe (e.g., ‘*72’).
Call Forward Unconditional
Deactivation
[SuppServCodeCFUDeact]
Defines the prefix code for deactivating Call Forward Unconditional
Deactivation sent to the softswitch.
The valid value is a string. The default is an empty string.
Note: The string must be enclosed in single apostrophe (e.g., ‘*72’).
Call Forward on Busy
[SuppServCodeCFB]
Defines the prefix code for activating Call Forward on Busy sent to
the softswitch.
The valid value is a string. The default is an empty string.
Note: The string must be enclosed in single apostrophe (e.g., ‘*72’).
Call Forward on Busy
Deactivation
[SuppServCodeCFBDeact]
Defines the prefix code for deactivating Call Forward on Busy
Deactivation sent to the softswitch.
The valid value is a string. The default is an empty string.
Note: The string must be enclosed in single apostrophe (e.g., ‘*72’).
To Next Page
Loading...
