SIP User's Manual 492 Document #: LTRT-83310
Mediant 600 & Mediant 1000
Larger files (up to 10 MB) are stored in RAM, and should be loaded again (using
BootP/TFTP utility) after the device is reset.
The device can be provided with a professionally recorded English (U.S.) VP file.
Note: Voice Prompts are applicable only to Mediant 1000.
To generate and load the VP file:
1. Prepare one or more voice files using standard utilities.
2. Use the DConvert utility to generate the voiceprompts.dat file from the pre-recorded
voice messages (refer to the Product Reference Manual).
3. Load the voiceprompts.dat file to the device using TFTP (refer to the Product
Reference Manual) or the Web interface (see 'Loading Auxiliary Files' on page 483).
23.1.4 CAS Files
The CAS auxiliary files contain the CAS Protocol definitions that are used for CAS-
terminated trunks. You can use the supplied files or construct your own files. Up to eight
files can be loaded to the device. Different files can be assigned to different trunks
(CASTableIndex_x) and different CAS tables can be assigned to different B-channels
(CASChannelIndex).
The CAS files can be loaded to the device using the Web interface or ini file (see 'Loading
Auxiliary Files' on page 483).
Note: All CAS files loaded together must belong to the same Trunk Type (i.e., either
E1 or T1).
23.1.5 Dial Plan File
The Dial Plan file contains a list of up to eight dial plans, supporting a total of up to 8,000
user-defined, distinct prefixes (e.g. area codes, international telephone number patterns)
for the PSTN to which the device is connected. The Dial Plan is used for the following:
ISDN Overlap Dialing, FXS, and FXO collecting digit mode (Tel-to-IP calls): The file
includes up to eight patterns (i.e., eight dial plans). These allow the device to know
when digit collection ends, after which it starts sending all the collected (or dialed)
digits (in the INVITE message). This also provides enhanced digit mapping.
CAS E1 MF-CR2 (Tel-to-IP calls): Useful for E1 MF-CR2 variants that do not support
I-15 terminating digits (e.g., in Brazil and Mexico). The Dial Plan file allows the device
to detect end-of-dialing in such cases. The CasTrunkDialPlanName_x ini file
parameter determines which dial plan (in the Dial Plan file) to use for a specific trunk.
Note: To use this Dial Plan, you must also use a special CAS .dat file that supports
this feature (contact your AudioCodes sales representative).
Prefix tags (for IP-to-Tel routing): Provides enhanced routing rules based on Dial Plan
To Next Page
Loading...
