AudioCodes Mediant 600 - Serial Parameters; A.2.5 Serial Parameters

SIP User's Manual 560 Document #: LTRT-83310
Mediant 600 & Mediant 1000
A.2.5 Serial Parameters
The RS-232 serial parameters are described in the table below.
Table A-14: Serial Parameters
Parameter Description
[DisableRS232]
Enables the device's RS-232 (serial) port.
 [0] = Enabled (default)
 [1] = Disabled
The RS-232 serial port can be used to change the networking
parameters and view error/notification messages. For how to establish a
serial communication with the device, refer to the Installation Manual.
Note: For this parameter to take effect, a device reset is required.
EMS: Baud Rate
[SerialBaudRate]
Defines the RS-232 baud rate.
The valid values include the following: 1200, 2400, 9600, 14400, 19200,
38400, 57600, or 115200 (default).
Note: For this parameter to take effect, a device reset is required.
EMS: Data
[SerialData]
Defines the RS-232 data bit.
 [7] = 7-bit.
 [8] = 8-bit (default).
Note: For this parameter to take effect, a device reset is required.
EMS: Parity
[SerialParity]
Defines the RS-232 polarity.
 [0] = None (default).
 [1] = Odd.
 [2] = Even.
Note: For this parameter to take effect, a device reset is required.
EMS: Stop
[SerialStop]
Defines the RS-232 stop bit.
 [1] = 1-bit (default).
 [2] = 2-bit.
Note: For this parameter to take effect, a device reset is required.
EMS: Flow Control
[SerialFlowControl]
Defines the RS-232 flow control.
 [0] = None (default).
 [1] = Hardware.
Note: For this parameter to take effect, a device reset is required.