AudioCodes Mediant 600 - Configuring Account Table

Version 6.4 225 March 2012
SIP User's Manual 17. SIP Definitions
3. Click Submit to apply your changes.
4. To save the changes to flash memory, see 'Saving Configuration' on page 482.
17.3 Configuring Account Table
The Account Table page allows you to define up to 32 Accounts per Trunk Group (Served
Trunk Group) or source IP Group (Served IP Group). This is used for registration and/or
digest authentication (user name and password) to a destination IP address (Serving IP
Group). The Account table can be used, for example, to register to an ITSP on behalf of an
IP-PBX to which the device is connected. The registrations are sent to the Proxy Set ID
(see 'Configuring Proxy Sets Table' on page 200) associated with these Serving IP Groups.
A Trunk Group or source IP Group can register to more than one Serving IP Group (e.g.,
ITSP's). This can be achieved by configuring multiple entries in the Account table with the
same Served Trunk Group or Served IP Group, but with different Serving IP Groups, user
name/password, host name, and contact user values.
When using the Account table to register a Trunk Group (to a proxy server), if all trunks
pertaining to the Trunk Group are down, the device un-registers the trunks. If any trunk
belonging to the Trunk Group is returned to service, the device registers them again. This
ensures, for example, that the Proxy does not send INVITEs to trunks that are out of
service.
Notes:
• For viewing Account registration status, see Viewing Registration Status
on page 521.
• You can also configure the Account table using the ini file table
parameter Account (see 'Configuration Parameters Reference' on page
541).
 To configure Accounts:
1. Open the Account Table page (Configuration tab > VoIP menu > SIP Definitions
submenu > Account Table).
Figure 17-1: Account Table Page
2. To add an Account, in the 'Add' field, enter the desired table row index, and then click
Add. A new row appears.
3. Configure the Account parameters according to the table below.
4. Click the Apply button to save your changes.
5. To save the changes, see 'Saving Configuration' on page 482.
6. To perform registration, click the Register button; to unregister, click Unregister. The
registration method for each Trunk Group is according to the setting of the
'Registration Mode' parameter in the Trunk Group Settings page.
Note:
For a description of the Web interface's table command buttons (e.g.,
Duplicate and Delete), see 'Working with Tables' on page 44.