AudioCodes Mediant 600 - Configuring FXO Settings

SIP User's Manual 324 Document #: LTRT-83310
Mediant 600 & Mediant 1000
18.6.4 Configuring FXO Settings
The FXO Settings page allows you to configure the device's specific FXO parameters. For
a description of these parameters, see 'Configuration Parameters Reference' on page 541.
Note: The FXO Settings page is available only for FXO interfaces.
 To configure the FXO parameters:
1. Open the FXO Settings page (Configuration tab > VoIP menu > GW and IP to IP
submenu > Analog Gateway submenu > FXO Settings).
Figure 18-23: FXO Settings Page
2. Configure the parameters as required.
3. Click Submit to apply your changes.
4. To save the changes to flash memory, see 'Saving Configuration' on page 482.