AudioCodes Mediant 600 - Configuring Caller Display Information

Version 6.4 327 March 2012
SIP User's Manual 18. GW and IP to IP
18.6.7 Configuring Caller Display Information
The Caller Display Information page allows you to define a caller identification string (Caller
ID) for FXS and FXO ports and enable the device to send the Caller ID information to IP
when a call is made. The called party can use this information for caller identification. The
information configured on this page is sent in an INVITE message in the From header. For
information on Caller ID restriction according to destination/source prefixes, see
'Configuring Number Manipulation Tables' on page 256.
 To configure the Caller Display Information:
1. Open the Caller Display Information page (Configuration tab > VoIP menu > GW and
IP to IP submenu > Analog Gateway submenu > Caller Display Information).
2. In the 'Caller ID/Name' field corresponding to the desired port, enter the Caller ID
string (up to 18 characters).
3. From the 'Presentation' drop-down list, select one of the following:
• Allowed [0] - sends the string defined in the 'Caller ID/Name' field when a Tel-to-
IP call is made using the corresponding device port.
• Restricted [1] - the string defined in the 'Caller ID/Name' field is not sent.
4. Click Submit to apply your changes.
5. To save the changes to flash memory, see 'Saving Configuration' on page 482.
Notes:
• When FXS ports receive 'Private' or 'Anonymous' strings in the From
header, they don't send the calling name or number to the Caller ID
display.
• If Caller ID name is detected on an FXO line (EnableCallerID = 1), it is
used instead of the Caller ID name defined on this page.
• When the 'Presentation' field is set to 'Restricted', the Caller ID is sent to
the remote side using only the P-Asserted-Identity and P-Preferred-
Identity headers (AssertedIdMode).
• The value of the 'Presentation' field can be overridden by configuring the
'Presentation' field in the Source Number Manipulation table (see
'Configuring Number Manipulation Tables' on page 256).
• You can also configure the Caller Display Information table using the ini
file table parameter CallerDisplayInfo.