Version 6.4 213 March 2012
SIP User's Manual 15. Enabling Applications
15 Enabling Applications
The device supports the following main applications:
Stand-Alone Survivability (SAS) application
IP to IP (IP2IP) application
The procedure below describes how to enable these applications. Once an application is
enabled, the Web GUI provides menus and parameter fields relevant to the application.
Notes:
• This page displays the application only if the device is installed with the
relevant Software Upgrade Key supporting the application (see 'Loading
Software Upgrade Key' on page 497).
• The IP2IP application is applicable only to Mediant 1000.
• For configuring the SAS application, see 'Stand-Alone Survivability (SAS)
Application' on page 381.
• For an overview of the IP2IP application and configuration examples, see
IP-to-IP Routing Application on page 360.
• For enabling an application, a device reset is required.
• The Gateway and IP-to-IP applications are depicted in the Web interface
as "GW" and "IP2IP" respectively.
To enable an application:
1. Open the Applications Enabling page (Configuration tab > VoIP menu >
Applications Enabling submenu > Applications Enabling).
Figure 15-1: Applications Enabling Page
2. From the relevant application drop-down list, select Enable.
3. Save (burn) the changes to the device's flash memory with a device reset (see 'Saving
Configuration' on page 482).
To Next Page
Loading...
