SIP User's Manual 628 Document #: LTRT-83310
Mediant 600 & Mediant 1000
Parameter Description
TelProfile_EnableVo
iceMailDelay
Enable Voice Mail
Delay
-
TelProfile_DialPlanI
ndex
Dial Plan Index DialPlanIndex
TelProfile_Enable91
1PSAP
Enable 911 PSAP Enable911PSAP
TelProfile_SwapTelT
oIpPhoneNumbers
Swap Tel To IP
Phone Numbers
SwapTEl2IPCalled&Callin
gNumbers
TelProfile_EnableA
GC
Enable AGC EnableAGC
TelProfile_ECNlpMo
de
EC NLP Mode ECNLPMode
TelProfile_DigitalCut
Through
- DigitalCutThrough
The following parameters are applicable only to analog interfaces:
EnableReversePolarity, EnableCurrentDisconnect, MWIAnalog,
MWIDisplay, EnableDIDWink, IsTwoStageDial, DisconnectOnBusyTone,
and Enable911PSAP.
The parameter IpPreference determines the priority of the Tel Profile (1 to
20, where 20 is the highest preference). If both IP and Tel Profiles apply to
the same call, the coders and common parameters (i.e., parameters
configurable in both IP and Tel Profiles) of the preferred profile are applied
to that call. If the Tel and IP Profiles are identical, the Tel Profile
parameters take precedence.
The parameter EnableVoiceMailDelay is applicable only if voice mail is
enabled globally (using the VoiceMailInterface parameter).
For a description of using ini file table parameters, see 'Configuring ini File
Table Parameters' on page 84.
A.11 Channel Parameters
This subsection describes the device's channel parameters.
A.11.1 Voice Parameters
The voice parameters are described in the table below.
Table A-33: Voice Parameters
Parameter Description
Web/EMS: Input Gain
[InputGain]
Defines the pulse-code modulation (PCM) input gain control (in
decibels). This parameter sets the level for the received
(Tel/PSTN-to-IP) signal.
The valid range is -32 to 31 dB. The default value is 0 dB.
Note: This parameter can also be configured per IP Profile, using
the IPProfile parameter (see 'Configuring IP Profiles' on page
219) and per Tel Profile, using the TelProfile parameter (see
To Next Page
Loading...
