AudioCodes Mediant 600 - Configuring SNMP Trap Destinations

SIP User's Manual 76 Document #: LTRT-83310
Mediant 600 & Mediant 1000
3. Click Submit to apply your changes.
4. To save the changes to flash memory, see 'Saving Configuration' on page 482.
To delete a community string, select the Delete check box corresponding to the community
string that you want to delete, and then click Submit.
Table 5-1: SNMP Community String Parameters Description
Parameter Description
Community String
 Read Only [SNMPReadOnlyCommunityString_x]: Up to five
read-only community strings (up to 19 characters each). The
default string is 'public'.
 Read / Write [SNMPReadWriteCommunityString_x]: Up to
five read / write community strings (up to 19 characters each).
The default string is 'private'.
Trap Community String
[SNMPTrapCommunityString]
Community string used in traps (up to 19 characters).
The default string is 'trapuser'.
5.2 Configuring SNMP Trap Destinations
The SNMP Trap Destinations page allows you to configure up to five SNMP trap
managers.
 To configure SNMP trap destinations:
1. Open the SNMP Trap Destinations page (Maintenance tab > System menu >
Management submenu > SNMP submenu > SNMP Trap Destinations).
Figure 5-1: SNMP Trap Destinations Page
2. Configure the SNMP trap manager parameters according to the table below.
3. Click Submit to apply your changes.
4. To save the changes to flash memory, see 'Saving Configuration' on page 482.
Note: Only table row entries whose corresponding check boxes are selected are
applied when clicking Submit; otherwise, settings revert to their defaults.