AudioCodes Mediant 600 - Static Routing Parameters

SIP User's Manual 546 Document #: LTRT-83310
Mediant 600 & Mediant 1000
Parameter Description
parameter to a value other than any VLAN ID in the table.
[EnableNTPasOAM]
Defines the application type for NTP services.
 [1] = OAMP (default)
 [0] = Control.
Note: For this parameter to take effect, a device reset is
required.
[VLANSendNonTaggedOnNative]
Determines whether to send non-tagged packets on the native
VLAN.
 [0] = Sends priority tag packets (default).
 [1] = Sends regular packets (with no VLAN tag).
Note: For this parameter to take effect, a device reset is
required.
A.1.3 Static Routing Parameters
The static routing parameters are described in the table below.
Table A-3: Static Routing Parameters
Parameter Description
Static IP Routing Table
Web/EMS: IP Routing
Table
[StaticRouteTable]
Defines up to 30 static IP routing rules for the device. These rules can be
associated with IP interfaces defined in the Multiple Interface table
(InterfaceTable parameter). The routing decision for sending the
outgoing IP packet is based on the source subnet/VLAN. If not
associated with an IP interface, the static IP rule is based on destination
IP address.
When the destination of an outgoing IP packet does not match one of the
subnets defined in the Multiple Interface table, the device searches this
table for an entry that matches the requested destination host/network. If
such an entry is found, the device sends the packet to the indicated
router (i.e., next hop). If no explicit entry is found, the packet is sent to
the default gateway according to the source interface of the packet (if
defined).
The format of this parameter is as follows:
[ StaticRouteTable ]
FORMAT StaticRouteTable_Index = StaticRouteTable_InterfaceName,
StaticRouteTable_Destination, StaticRouteTable_PrefixLength,
StaticRouteTable_Gateway, StaticRouteTable_Description;
[ \StaticRouteTable ]
Notes:
 The Gateway address must be in the same subnet as configured in
the Multiple Interface table for (refer to 'Configuring IP Interface
Settings' on page 102).

The StaticRouteTable_Description parameter is a string value of up to
30 characters.
 The metric value (next hop) is automatically set to 1.