Version 6.4 545 March 2012
SIP User's Manual A. Configuration Parameters Reference
Parameter Description
To configure multiple IP interfaces in the Web interface and
for a detailed description of the table's parameters, see
'Configuring IP Interface Settings' on page 102).
For a description of configuring ini file table parameters, see
'Configuring ini File Table Parameters' on page 84.
Single IP Network Parameters
Web: IP Address
EMS: Local IP Address
[LocalOAMIPAddress]
Defines the device's source IP address of the operations,
administration, maintenance, and provisioning (OAMP) interface
when operating in a single interface scenario without a Multiple
Interface table.
The default value is 0.0.0.0.
Note: For this parameter to take effect, a device reset is
required.
Web: Subnet Mask
EMS: OAM Subnet Mask
[LocalOAMSubnetMask]
Defines the device's subnet mask of the OAMP interface when
operating in a single interface scenario without a Multiple
Interface table.
The default subnet mask is 0.0.0.0.
Note: For this parameter to take effect, a device reset is
required.
Web: Default Gateway Address
EMS: Local Def GW
[LocalOAMDefaultGW]
Defines the Default Gateway of the OAMP interface when
operating in a single interface scenario without a Multiple
Interface table.
VLAN Parameters
Web/EMS: VLAN Mode
[VLANMode]
Enables the VLAN functionality.
[0] Disable (default).
[1] Enable = VLAN tagging (IEEE 802.1Q) is enabled.
Notes:
For this parameter to take effect, a device reset is required.
To operate with multiple network interfaces, VLANs must be
activated.
VLANs are available only when booting the device from
flash. When booting using BootP/DHCP protocols, VLANs
are disabled to allow easier maintenance access. In this
scenario, multiple network interface capabilities are
unavailable.
Web/EMS: Native VLAN ID
[VLANNativeVLANID]
Defines the VLAN ID to which untagged incoming traffic is
assigned. Outgoing packets sent to this VLAN are sent only with
a priority tag (VLAN ID = 0).
When this parameter is equal to one of the VLAN IDs in the
Multiple Interface table (and VLANs are enabled), untagged
incoming traffic is considered as incoming traffic for that
interface. Outgoing traffic sent from this interface is sent with
the priority tag (tagged with VLAN ID = 0).
When this parameter is different from any value in the 'VLAN ID'
column in the table, untagged incoming traffic is discarded and
all outgoing traffic is tagged.
Note: If this parameter is not set (i.e., default value is 1), but
one of the interfaces has a VLAN ID configured to 1, this
interface is still considered the ‘Native’ VLAN. If you do not wish
to have a ‘Native’ VLAN ID and want to use VLAN ID 1, set this
To Next Page
Loading...
