AudioCodes Mediant 600 - SAS Configuration; General SAS Configuration; Enabling the SAS Application; Configuring Common SAS Parameters

SIP User's Manual 388 Document #: LTRT-83310
Mediant 600 & Mediant 1000
19.2 SAS Configuration
SAS supports various configuration possibilities, depending on how the device is deployed
in the network and the network architecture requirements. This section provides step-by-
step procedures on configuring the SAS application, using the device's Web interface.
The SAS configuration includes the following:

General SAS configuration that is common to all SAS deployment types (see 'General
SAS Configuration' on page 388)

SAS outbound mode (see 'Configuring SAS Outbound Mode' on page 391)

SAS redundant mode (see 'Configuring SAS Redundant Mode' on page 392)

Gateway and SAS applications deployed together (see 'Configuring Gateway
Application with SAS' on page 392)

Optional, advanced SAS features (see 'Advanced SAS Configuration' on page 396)
19.2.1 General SAS Configuration
This section describes the general configuration required for the SAS application. This
configuration is applicable to all SAS modes.
19.2.1.1 Enabling the SAS Application
Before you can configure SAS, you need to enable the SAS application on the device.
Once enabled, the device's Web interface provides the SAS pages for configuring SAS.
Note: The SAS application is available only if the device is installed with the SAS
Software Upgrade Key. If your device is not installed with the SAS feature,
contact your AudioCodes representative.
 To enable the SAS application:
1. Open the Applications Enabling page (Configuration tab > VoIP menu >
Applications Enabling > Applications Enabling).
2. From the 'SAS Application' drop-down list, select Enable.
Figure 19-8: Enabling SAS Application
3. Click Submit.
4. Save the changes to the flash memory with a device reset; after the device resets, the
SAS menu appears and you can now begin configuring the SAS application.
19.2.1.2 Configuring Common SAS Parameters
The procedure below describes how to configure SAS settings that are common to all SAS
modes. This includes various SAS parameters as well as configuring the Proxy Set for the
SAS proxy (if required). The SAS Proxy Set ID defines the address of the UAs' external
proxy.