AudioCodes Mediant 600 - Security Parameters; General Parameters; A.4 Security Parameters

SIP User's Manual 568 Document #: LTRT-83310
Mediant 600 & Mediant 1000
A.4 Security Parameters
This subsection describes the device's security parameters.
A.4.1 General Parameters
The general security parameters are described in the table below.
Table A-19: General Security Parameters
Parameter Description
Web: Voice Menu
Password
[VoiceMenuPassword]
Defines the password for accessing the device's voice menu, used for
configuring and monitoring the device. To activate the menu, connect a
POTS telephone (i.e., to the FXS port) and dial *** (three stars) followed
by the password.
The default value is 12345.
Notes:
 To disable the Voice Menu, do any of the following:

Set the VoiceMenuPassword parameter to 'disable'.

Change the Web login password for the Admin user from its
default value (i.e., 'Admin') to any other value, and then reset the
device.
 This parameter is applicable only to FXS interfaces.
 For more information on the Voice menu, refer to the Installation
Manual.
[EnableSecureStartup]
Enables the Secure Startup mode. In this mode, downloading the ini file
to the device is restricted to a URL provided in initial configuration (see
the parameter IniFileURL) or using DHCP.
 [0] Disable (default).
 [1] Enable = disables TFTP and allows secure protocols such as
HTTPS to fetch the device configuration.
For more information on Secure Startup, refer to the Product Reference
Manual.
Note: For this parameter to take effect, a device reset is required.
Web: Internal Firewall Parameters
EMS: Firewall Settings
[AccessList]
This parameter table defines the device's access list (firewall), which
defines network traffic filtering rules. For each packet received on the
network interface, the table is scanned from the top down until a matching
rule is found. This rule can either deny (block) or permit (allow) the
packet. Once a rule in the table is located, subsequent rules further down
the table are ignored. If the end of the table is reached without a match,
the packet is accepted.
The format of this parameter is as follows:
[AccessList]
FORMAT AccessList_Index = AccessList_Source_IP,
AccessList_Source_Port, AccessList_PrefixLen, AccessList_Source_Port,
AccessList_Start_Port, AccessList_End_Port, AccessList_Protocol,
AccessList_Use_Specific_Interface, AccessList_Interface_ID,
AccessList_Packet_Size, AccessList_Byte_Rate, AccessList_Byte_Burst,
AccessList_Allow_Type;
[\AccessList]